I have a problem with the sync. When I start the sync, for example first the Master and them the slave the sync use to work perfect but when the video finish and it start again there is a difference of frames. It´s very strange, because sometime at the begining sync perfect but sometimes not, I´m using the same video. I tried to adjust the sensibility in the conf file but it didn´t not work.
When the loop starts the sync needs 13 sencods to sync the slave with the master, and I told you up sometimes sync perfect after this 13 seconds and sometimes there are some frames of difference.
I tried with different videos, with a different switch, with a direct ethernet cable, etc.
My config is:
2 X Raspberry Pi 2
Conection between direct ethernet link.
Hi everyone,
I have a problem with the sync. When I start the sync, for example first the Master and them the slave the sync use to work perfect but when the video finish and it start again there is a difference of frames. It´s very strange, because sometime at the begining sync perfect but sometimes not, I´m using the same video. I tried to adjust the sensibility in the conf file but it didn´t not work.
When the loop starts the sync needs 13 sencods to sync the slave with the master, and I told you up sometimes sync perfect after this 13 seconds and sometimes there are some frames of difference.
I tried with different videos, with a different switch, with a direct ethernet cable, etc.
My config is:
2 X Raspberry Pi 2 Conection between direct ethernet link.
Best Regards.