not sure what I was thinking when I wrote it, it's far more complicated than it needs to be!
while writing the ARCHITECTURE document realized it only needs to do a single CUT operation with the shape being the smaller solid and the tool being the larger one
hopefully this will result in simpler geometry being written out at the end, which will make the mesher's job easier as well
not sure what I was thinking when I wrote it, it's far more complicated than it needs to be!
while writing the
ARCHITECTUREdocument realized it only needs to do a singleCUToperation with the shape being the smaller solid and the tool being the larger onehopefully this will result in simpler geometry being written out at the end, which will make the mesher's job easier as well