Closed Jporterz28 closed 4 years ago
You need to enable DPI on the controller and in the poller config. Two spots.
Did you figure it out?
Yes! Thanks for following up. I went through everything again, and I think the issue was that I was restarting Grafana instead of UniFi-poller after enabling DOI in the config file. Just a bit of confusion on my end.
On Wed, Jun 24, 2020 at 1:50 PM David Newhall II notifications@github.com wrote:
Did you figure it out?
— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/unifi-poller/dashboards/issues/9#issuecomment-648970510, or unsubscribe https://github.com/notifications/unsubscribe-auth/AQAGHLMHXF2VPIDPPPD7IJDRYI4EZANCNFSM4OCLEF6A .
I'm new to Grafana, and actually Unifi as well, I've loaded 4 of the other dashboards and all work well. The Client DPI dashboard is not populating the Sites menu. I'm running the latest Grafana 7.0.3_armhf on a Raspberry Pi 4, using InfluxDB, not sure the version there. Of course, since there is no site selected, it shows no data available. Thanks for listening to my newb-ness!