Threshold set in sensor config screen is not honored

[djanderson]

I set the threshold for my sensor on the sensor-config screen to -80:

But the threshold keeps reverting to -26, and my occupancy is 0:

[ranganathanm]

Note that this is dbm/Hz so if you want to set your threshold to -75, you have to enter -127.55 on this screen.

[djanderson]

Summarizing discussion on slack:

• Inputting threshold in dBm/Hz while all plots display threshold in dBm is confusing for the end user
• Possible solutions mentioned:
  • Add a dropdown to the sensor config screen that allows input in dBm/Hz OR dBm and continue to display dBm on occupancy charts
  • Use only dBm as threshold input, but display dBm/Hz (reverse of current setup)
  • Use dBm consistently
  • Use dBm/Hz consistently

@MichaelCotton, preferences?

[ranganathanm]

I adopted a hybrid solution. You enter the parameters and "Check". This does the conversion and then "Apply" the settings.

[ranganathanm]

Doug - please comment if you found the interface good enough.

[djanderson]

This looks good.