issues
search
uwa-aerospace
/
sx1262-pid
Platform independent driver for the SX1262 LoRa module by Semtech
0
stars
0
forks
source link
New LoRa module driver requirements
#1
Open
txvvgnx
opened
1 week ago
txvvgnx
commented
1 week ago
[ ] Limit output power in
SetTxParams
to
10dBm
. Output power should not be higher than 13dBm.
[ ] Use
SetDIO3AsTCXOCtrl
with 3.3V (
0x07
) TCXO supply voltage. Check for errors at the end of the setup function.
[ ] Set RX boosted mode to true
txvvgnx
commented
2 days ago
[ ] Look into making
sx1262_wait_for_command_completion
read the BUSY line instead of polling chip status (less expensive)
SetTxParams
to 10dBm. Output power should not be higher than 13dBm.SetDIO3AsTCXOCtrl
with 3.3V (0x07
) TCXO supply voltage. Check for errors at the end of the setup function.