search

vcc-gnd / YD-ESP32-S3

YD-ESP32-S3 Micropython VCC-GND Studio
120 stars 23 forks source link

Running esp-iot UVC camera project on this board #3

Open MrNash97 opened 1 year ago

MrNash97 commented 1 year ago

I want to try the UVC camera project from the esp-iot-solution GitHub page. I noticed a few things on the hardware description and assumed this board fell into category ii. image I try to give it a go and plug my UVC camera into the USB-OTG port, but the camera doesn't get powered on. I tried to check the output voltage from the USB-OTG but nothing.

Is there a way to make the USB-OTG port deliver 5V DC output? I'm using V1.3, and here is the picture of my board. image

mrnrone commented 14 hours ago

I am not sure what's the best solution here. I am just guessing but you might need to do a little more soldering.

https://forum.arduino.cc/t/chinese-esp32-s3-5v-pin-warning/1192758

Another thread about those soldering pads:

https://www.reddit.com/r/esp32/comments/10rdngp/thirdparty_esp32s3_development_boards_inout_and/?rdt=39953

I hope it helps.

Btw how should those soldering pads to be used? What happens if I solder in-out or usb-otg? (Rgb is okay :))