Custom PCB - missing CPL file

[dan-s-github]

Thanks for making this project available, I ordered the KNX Interface and discovered that a lot of information that is available on the LAN Interface is missing. So this would be a perfect addition to my current system

I like the custom pub design and think this could also be used for other can based integrations.

Went to https://jlcpcb.com to order a set of fully assembled boards.

To order the fully assembled board I first uploaded the Gerber ZIP file and after activating and confirming PCB Assembly a popup opens which requires to file to be uploaded

• BOM File
• CPL File

The BOM file is currently present in the repo but the CPL file is missing, is this also available or is there another way to get a fully assembled board?

[dan-s-github]

ordered one of those to see if it would also work

https://shop.m5stack.com/products/atom-canbus-kit-ca-is3050g

https://docs.m5stack.com/en/atom/atom_can

uses GPIO19 and GPIO22, so open PR regarding configurable GPIO would be nice to have merged

[vekexasia]

wow.. didnt see it. it would have been nice to have it would've spared somuch time :D

[vekexasia]

@dan-s-github merged.

[dan-s-github]

just missing the 12V to 5V converter which you added, might be able to add one inside the case and connect it to the empty pin on the connector

[vekexasia]

Ah. thne it's not good for me :D

[dan-s-github]

can you add the full schematics of your custom pub to the repo for completeness?

[vekexasia]

[JoooostB]

@dan-s-github Did you manage to get a CPL file? Or have you walked the manual route?

[dan-s-github]

As mentioned further up I ordered the m5stack kit and are using this powering the atom through usb. The first 12v - 5v converter from aliexpress didn't last long, other version in transit...