Armed Mousetrap-Igniter Assemblies on a one-tank bomb fail to trigger when walked over

[ghost]

If you have VV privileges:

1. Open sandbox panel
2. spawn canister -> Toxins
3. VV, air contents, temp - 374.15
4. Spawn a tank - any, and the portable airpump/scrubber needed to empty it
5. Fill tank to 850kPa of the 374.15K Plasma
6. Spawn Oxygen canister
7. Set canister target pressure to 851 kPa and open valve - Giving a small CO2 buffer. If you just dump to the end-total the room temp O2 cools the plasma faster than the CO2 heats it and it falls below the flashpoint
8. Close the valve, set target pressure to 941 kPa and open the valve
9. Close the valve and remove tank
10. spawn a mousetrap and igniter. Screwdriver both and attach to make the assembly
11. Screwdriver to ready and arm the assembly
12. Wield the readied assembly and click the plasma tank to attach it
13. Light your welder and click the plasma tank to bore an ignition hole into it. It's now ready to blow.
14. run back and forth over it and it fails to trigger Pic related, It wasn't a dud

If you don't have VV:

1. Empty a good 1/3 out of your plasma canister. Use two connectors, a gas pump and an empty cansiter
2. Hook it up to a heater set at 374.15. Make sure the canister says 101C at least when you unhook it.
3. Follow method 1 from step 4

We need this for passive defense against aliens and other nasties as it will be extremely effective to have the mousetraps immediate spark vs the prox-igniter assemblies delay delay

If you need to take the assembly off attack the tank with a lit welder to close the ignition hole then wrench to disconnect.

I tested it with a signaller-igniter assembly on the tank and a mousetrap-signaller assembly on the same tile and it worked fine.

[N3X15]

Fix committed.

[ghost]

Still borked