search

vichug123 / neuron-replicator

Automatically exported from code.google.com/p/neuron-replicator
0 stars 0 forks source link

Heater Relay Board Design & Layout #36

Open GoogleCodeExporter opened 8 years ago

GoogleCodeExporter commented 8 years ago 
Design schematic and layout for Relay PCB.

Status: Should be good to go, pending review from Alex. Schematic and layout 
are posted to SVN for viewing.

~ 4 hours invested in this task thus far.

Original issue reported on code.google.com by Shadow77...@gmail.com on 8 Mar 2012 at 1:19

GoogleCodeExporter commented 8 years ago 
3/17/12 Update: Rev 2 Relay PCB up on SVN. Replaces output rectangular header 
with 0.100" pitch screw terminals, adds totem pole high-side driving circuit 
for MOSFET, adds 8-32 mounting holes. Diode D1 swapped for a slightly smaller 
part.

~ 2 hours spent on the update.

Original comment by Shadow77...@gmail.com on 17 Mar 2012 at 8:30

GoogleCodeExporter commented 8 years ago 
Corrected the ribbon connector width on this layout (was .26", needed to be 
.36" to account for the width of the shroud) and updated the DXF to indicate 
it. Didn't take long on my part, but it's worth noting for when Mark gets back.

Original comment by Shadow77...@gmail.com on 20 May 2012 at 3:39

GoogleCodeExporter commented 8 years ago 
Brought all components topside, added LED.

~ 1 hr spent on this update.

Original comment by Shadow77...@gmail.com on 8 Jun 2012 at 6:12