search

victorlucachi / void_ergo

A handwired split keyboard, running QMK firmware
221 stars 14 forks source link

Adding hotswap sockets #16

Open andrwui opened 1 month ago

andrwui commented 1 month ago

Hi!

Would it be possible to add hotswap sockets to the build without using a pcb? I'm asking because I like to change switches every now and then, and as the build isn't planed with hotswap sockets in mind, they may not fit in the casing.

Thank you for the amazing design!

victorlucachi commented 1 month ago

hey, thank you for the kind words.

you could adapt the switch plates to fit hotswap sockets, but it might be just a little bit too tight; there's almost no room to spare towards the front of the case, under the thumb cluster, and above the controller as well.