search

vinodstanur / open9x

Automatically exported from code.google.com/p/open9x
0 stars 0 forks source link

Switch-Warning (S-Warning) in Model Menu is not configurable on transmitter #185

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago 
Which board (stock / gruvin9x / sky9x) are you using?
stock

What is your open9x FW version?
r1855

What is your open9x EEPROM version?
212-1

What steps will reproduce the problem?
1. Long press right and after this select a model
2. In the first setup page for the model there is a menu item called S-Warning
3. The only thing you can do is to toggle S-Warning On or Off

What is the expected output? What do you see instead?
I expect to be able to configure the state for the switches like it is in the 
next option called Ctr Beep. But this is not possible on the transmitter. 
Whatever key I pressed I always just enable or disable S-Warning in total. No 
switch state can be defined.

Please provide any additional information below.
Interestingly the same option in Companion9x on a Windows PC is configurable. 
And the changed configuration can be loaded to the transmitter and actually 
works. You can see the configuration also on the transmitter, because some 
letters are shown inverted. However you can't change them.

Additionally I want to remark there should be a "don't care" option as well for 
each switch. This enables you just to configure the switches of intereset and 
not be forced to generate a warning for all switches.

Original issue reported on code.google.com by open.20.fsguruh@xoxy.net on 27 Jan 2013 at 1:09

GoogleCodeExporter commented 8 years ago 
Hi,
you can autodetect actual states by pressing Long-MENU. This option is not 
three-state yet (Issue 36).
From Open9x Manual:
S-warning: If ON will show a warning when the switches are not at the default
position when the Tx is turned on. The Tx will not output a signal until the 
alert is
cleared. To set “default” position of switches set all switches to the 
appropriate positions and press [MENU LONG].

Original comment by mho...@gmail.com on 27 Jan 2013 at 6:41

GoogleCodeExporter commented 8 years ago 
Right. I merge with Issue 36. 3-states warnings is in my plate, but there is 
some work ...

Original comment by bson...@gmail.com on 27 Jan 2013 at 7:10