search

vinz486 / fingerprint-r503-mqtt

This is a fingerprint scanner software driver that maps recognition events to MQTT messages for IoT or home automation integration.
26 stars 6 forks source link

Wifimanager AP doesnt show up #5

Open epictechlab opened 3 years ago

epictechlab commented 3 years ago

Hi there,

I'm struggled with the orginal Code from "Everythingsmarthome" so i've desided to give your fork a try. I've flashed your code on my Wemos D1 mini. Which works flawlessly. But the Wifimanager AP doesn't show up. I've tested it with 3 Phones and 1 PC. but i Cant find the AP.

I've been searching through your Code where i cant put my Wifi and mqtt Parameters in. I'm new to Wifimanager.h so i can't find the right lines. Can you give me a hint?

Best regards

epictechlab commented 3 years ago

The Serial Monitor shows:

WM (I assume its WifiManager) config is incorrect. could cause AP doesnt show up.

vinz486 commented 3 years ago

Hi, can you try to reset?

Zappelphilipp commented 2 years ago

seems like i do have the same problem flasing my wemos d1 works but then no AP shows up. tried 2 differend wemos boards.

console output just says:

load 0x4010f000, len 3460, room 16 
tail 4
chksum 0xcc
load 0x3fff20b8, len 40, room 4 
tail 4
chksum 0xc9
csum 0xc9
v0005c8a0
~ld

EDIT: never mind, i did two things wrong: