Cant able to send L2 protocol data with Ostinato

[GoogleCodeExporter]

What steps will reproduce the problem?
1.In the protocol selection chosen etherner II , 802.3 LLC, 802.3 LLC SNAP
2.Try to send this protocol data from fixed source to fixed destination by 
giving source and destination MAC respectively
3.Steam data also selected , for example 10000 packets.

What is the expected output? What do you see instead?

Observed result: When i am trying to listen this generated traffic from another 
port on the switch , nothing was shown from ostinato. But other communication 
works fine on the switch.
Here i am trying to generate extra traffic on ethernet based network switch.
PS: Both source and destination machine running with ostinato and drone.
If this possible sending the data like this on ostinato how much maximum data 
it supports in Mbps.

What version and revision of the product are you using (available in the
About dialog)? On what operating system?
Ostinato 0.2

Please provide any additional information below.

Original issue reported on code.google.com by chi...@gmail.com on 13 Oct 2010 at 9:25

[GoogleCodeExporter]

Chirug,

A few questions -

Are you using port mirroring on the switch?
Can you run wireshark on the source machine and check if Ostinato is generating 
packets?
Can you save the Ostinato stream and attach it here?

btw you need to run Ostinato (and drone) only on the source machine, not the 
destination.

Regards,
Srivats

Original comment by pstav...@gmail.com on 13 Oct 2010 at 12:12

• Changed state: Reviewed

[GoogleCodeExporter]

Hi,
can not able to repeat this problem again. Once i got this problem , that time 
could not able to save the captured wireshrk files. Any way i will update here 
if i repeat the problem.

Original comment by chi...@gmail.com on 19 Oct 2010 at 3:44

[GoogleCodeExporter]

ok. thanks for the update. post here if you are able to repeat the problem.

Original comment by pstav...@gmail.com on 19 Oct 2010 at 4:06

• Changed state: WontFix