Pyduino is a library which allows you to communicate with Arduino boards loaded with the Firmata protocol from within Python. It currently supports version 2 of the Firmata protocol.
Hi,
thanks for pyduino. I'm using it successfully on Linux with my Arduino
(Duemillanuove) and extended it to support stepper motors (by adding some extra
sysex commands to the firmata protocol).
My Problem: One of my motors uses A0,A1 alias D14,D15 as digital output.
But you define the Arduino board to only know about 14 digital pins.
Since any analog pin can be also used as an analog output (or input) pin, one
should define the Arduino board to have 14 + 6 = 20 possible digital pins.
However, doing the book keeping right, that A0 cannot be used both as analog
input and as digital i or o at the same time might be somewhat involved....
Thanks again,
Sebastian Haase
Original issue reported on code.google.com by seb.ha...@gmail.com on 6 Jan 2012 at 6:49
Original issue reported on code.google.com by
seb.ha...@gmail.com
on 6 Jan 2012 at 6:49