When trying to capping after reaching a certain gravity of fermenting wort, this option turned out to be not working. That is, the CONTROL page - the CAPPING CONTROL-GRAVITY tab does not work. Moreover, the TIME and MANUAL tabs work correctly. Firmware v4.1. When communicating with other users, it turned out that they had the same bug on ESP8266 and on ESP32 (my case). To exclude the absence of gravity data from iSpindel, I inform you: the refrigerator temperature control by SG works correctly in the Beer Profile.
In fact: Pin invert, the current GRAVITY is 1.040; when you enter SG in the MAPPING CONTROL -GRAVITY tab is 1.038 and the pressure is 20 psi and apply the parameter, the valve closes immediately (this is incorrect) and begins to collect CO2. If Pin is Not invert and the current GRAVITY is 1.040: when you enter SG in the CAPPING CONTROL t-GRAVITY tab 1.038 and a pressure of 20 psi and apply the parameter, the valve does not close (this is correct), but when the wort reaches 1.038 or less, the valve remains open (this is incorrect).
Naturally, when installing the Pin, Invert the output and Not invert, relays are mounted are normally closed and normally open, respectively.
When trying to capping after reaching a certain gravity of fermenting wort, this option turned out to be not working. That is, the CONTROL page - the CAPPING CONTROL-GRAVITY tab does not work. Moreover, the TIME and MANUAL tabs work correctly. Firmware v4.1. When communicating with other users, it turned out that they had the same bug on ESP8266 and on ESP32 (my case). To exclude the absence of gravity data from iSpindel, I inform you: the refrigerator temperature control by SG works correctly in the Beer Profile. In fact: Pin invert, the current GRAVITY is 1.040; when you enter SG in the MAPPING CONTROL -GRAVITY tab is 1.038 and the pressure is 20 psi and apply the parameter, the valve closes immediately (this is incorrect) and begins to collect CO2. If Pin is Not invert and the current GRAVITY is 1.040: when you enter SG in the CAPPING CONTROL t-GRAVITY tab 1.038 and a pressure of 20 psi and apply the parameter, the valve does not close (this is correct), but when the wort reaches 1.038 or less, the valve remains open (this is incorrect). Naturally, when installing the Pin, Invert the output and Not invert, relays are mounted are normally closed and normally open, respectively.