Open gnurc opened 4 years ago
Hi again,
I changed the cut bit diameter in pcb2gcode to 2mm and now look better.
But if I executed profile out and cut
Is it possible to cut it and make it look like in the first image?
Why do you want to do that? I guess choosing a thin track width in pcbgcode generates the path you want
Curiosity, I thought it was better but I tried and cut well in one pass. You are right is enough so.
Hello,
When I run the job the spindle is milling on the edge, How can I make it go through the center? As if it were a single line.
https://imgur.com/a/6vYWtix
Is it possible to do it with bCNC or is it done when I generate the gerber file?
Best regards