search

voltizar / arducam-osd

Automatically exported from code.google.com/p/arducam-osd
0 stars 0 forks source link

Panel 2 not working correctly #40

Open GoogleCodeExporter opened 8 years ago

GoogleCodeExporter commented 8 years ago 
What steps will reproduce the problem?
1. Upload your Panel 2 settings to OSD
2. Enable OSD toggle channel
3. Toggle OSD channel through Tx

What is the expected output? 
To see the Panel 2 settings that I uploaded

What do you see instead?
"OVERSPEED" 100 with an hourglass symbol next to the 100.

What version of the product are you using? 
OSD Config 2.1.2.0 w OSD_20.hex

On what operating system?
Win7 64bit

Please provide any additional information below.

Original issue reported on code.google.com by orionaer...@gmail.com on 30 Dec 2012 at 8:03

GoogleCodeExporter commented 8 years ago 
What APM firmware are you flying: ArduCopter or ArduPlane?
For ArduCopter you should disable the warnings.
Also, are you sure that you have the latest CharSet?

Original comment by sbeni...@gmail.com on 7 Jan 2013 at 3:13

GoogleCodeExporter commented 8 years ago 
Same issue here. ArduPlane. Used charset which was included with 2.0 hex 
firmware and OSD configuration tool.

Original comment by pnikite...@gmail.com on 18 Jan 2013 at 5:23

GoogleCodeExporter commented 8 years ago 
APM 1.29. Arducopter 2.8.1 and yes I'm sure I have the latest Charset. I just 
came back from flying and the screen continuously switches to a different 
configuration on its own.

Original comment by orionaer...@gmail.com on 19 Jan 2013 at 9:54

GoogleCodeExporter commented 8 years ago 
Similar issue here.  Arduplane with latest Charset and Firmware.  I tried 
setting all values to "not enabled", writing each page, then resetting the 
values.  Oddly, when all values are set to zero, OSD won't get past boot 
sequence and video is a grey screen.  After resetting values, I get the same 
excact result: Panel 1 works great but panel two is a jumbled mess.

In addition since I have been re-flashing the chip, now cycling the panel view 
results in a brief view of the jarbled mess of panel two then automatically 
flips back to panel 1.  No access to either panel 2 or "OFF" mode now.  Still 
panel 1 is working fine.

Original comment by maslows...@gmail.com on 6 May 2013 at 3:27

GoogleCodeExporter commented 8 years ago 
As a clarification, I'm able to cycle panels.  It was due to a warning forcing 
panel 1 to be enabled.  With that issue understood, i'm still having problems 
with panel 2.  It does one of two things consistently:
1) "OVERSPEED  SOME NUMBER KM/H"
2) JUMBLED MESS OF VARIOUS PROPERTIES SCATTERED ON THE SCREEN

Original comment by maslows...@gmail.com on 7 May 2013 at 4:58