gsm shield not working

[GoogleCodeExporter]

when i connect pir sensor with gsm shield, gsm shield turn on for few seconds 
then turn off i also have used adaptor 12v 1amp but still same 
problem..............?

Original issue reported on code.google.com by veezo200...@gmail.com on 22 May 2012 at 4:56

[GoogleCodeExporter]

Does it work fine without it ?

Original comment by martines...@gmail.com on 22 May 2012 at 10:06

[GoogleCodeExporter]

my project is like when i send sms "pompeon" led turn on and when i send sms  
"pompeoff" led turn off this part work fine, but when i connect pir sensor with 
gsm shield when i turn on gsm shield it turn on for few seconds then turn off 
only when connect pirsensor i have also used adaptor 12v 1amp but same 
problem....

Original comment by veezo200...@gmail.com on 22 May 2012 at 10:44

[GoogleCodeExporter]

If you run the sketch without PIR, check that it works fine and then you 
connect the PIR. If the shield shut down can be an ampere problem. Does Arduino 
still work after the shield power-off? Can be a problem of PIR?

Original comment by martines...@gmail.com on 23 May 2012 at 9:59

[GoogleCodeExporter]

when i run sketch without PIR shield work fine but when i connect pir with 
shield it shutdown after few seconds.
The problem is that if i put code only for PIR like when sesnor detect anything 
led turn on shield work fine, but when i put code of sms automation and pir 
together then shield shut down and if i put code only for sms automation shield 
work fine.

Original comment by veezo200...@gmail.com on 23 May 2012 at 12:32

[GoogleCodeExporter]

Original comment by martines...@gmail.com on 11 Dec 2012 at 5:01

• Changed state: Done

[GoogleCodeExporter]

This issue section is not longer supported.
Please check the support page www.gsmlib.org 

Original comment by martines...@gmail.com on 6 Jul 2013 at 11:27

• Changed state: Fixed