w4mmp / MSCC-PW

1 stars 1 forks source link

Lost semi-break cw with 20220820 update #4

Closed BobW9BF closed 2 years ago

BobW9BF commented 2 years ago

Previous version dated 8-18 had flawless semi-break cw. Lost that function with new update. Also, long-standing issue of meter function (only A and T buttons turn red and only S units displayed on meter).

Thanks, Bob W9BF

ziplog.zip

w4mmp commented 2 years ago

Hi Bob, It works fine here. Are you sure semi break in is set?

Yes, only A and T are enabled since there is no Rego attached to the PC (and therefore no MFC or power meter).

73, Ron Patton

BobW9BF commented 2 years ago

Ron,

Thanks for the feedback. Perhaps the installation had a glitch. I’ll give it a try. I did have semi-break in checked.

Did the logs confirm anything?

I asked Stew if I could go back to 20220818 which worked fine. I’m concerned it will cause an issue with calibration settings. Will it?

Love the new MSCC. i have a Flex 6600 and an LP-PAN for my K3. Now it’s hard to operate without a panadapter.

Many thanks to you and Stew for your contributions to making the hobby fun.

73, Bob W9BF

On Aug 20, 2022, at 2:44 PM, W4MMP @.***> wrote:

 Hi Bob, It works fine here. Are you sure semi break in is set?

Yes, only A and T are enabled since there is no Rego attached to the PC (and therefore no MFC or power meter).

73, Ron Patton

— Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you authored the thread.

w4mmp commented 2 years ago

Hi Bob, Thanks! I'm glad you like the new MSCC.
Yes, You can go back to the previous release. It will not effect any of your calibration or other settings. I have not taken a look at the logs as yet.

w4mmp commented 2 years ago

The semi break in issue has been resolved. No defect in MSCC-PW.