search

wabbitguy / Kobra_Plus

Anycubic Kobra PLUS 3D Printer Firmware
GNU General Public License v3.0
18 stars 3 forks source link

Kobra 2 Plus #9

Closed Fajka0 closed 5 months ago

Fajka0 commented 5 months ago

Hello, could this update be extended to Kobra 2 Plus? Or is it also good for Kobra 2 Plus? For me, the most important thing is 100C bed temp.

wabbitguy commented 5 months ago

@Fajka0 The Kobra 2 PLUS runs a more or less custom version of Klipper, whereas the firmware for the original Kobra Plus runs Marlin and uses a different display and motherboard setup. The two, to my knowledge aren't interchangeable.

Anycubic limited the temp on the 2 PLUS to 105C (but they subtract 15C from the max allowed if I remember correctly) so that's why it's set to 90C.

I don't see any way around that limitation other than trying to hack into their closed off Klipper install. There's a bunch on Reddit trying to do that:

Kobra 2/Plus/Pro/Max Klipper

Mel