search

webaccess007 / er9x

Automatically exported from code.google.com/p/er9x
0 stars 1 forks source link

thr cut and thr hold scrolling menu #324

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
 thr cut and thr hold potentiometers scroll the menu up and down after I soldered the resistors and wires for tx and rx output. soldering is good, no bridges or so...

Original issue reported on code.google.com by mel...@gf-u.de on 2 Oct 2011 at 6:00

GoogleCodeExporter commented 9 years ago 
I just did the FrSky telemetry modification to a TH9x (redirecting "THR CUR" 
and "AIL D/R" to PC6 and PC7 of the Atmega chip. The "AIL D/R" switch works 
fine, but throwing the "THR CUT" switch is not registered by the TH9X. The thr 
hold pot causes menus to scroll, as described in Issue 324. A final piece of 
information is that the PC and PC6 pins are shorted, although no solder 
bridge/contact exists between them. I would guess that I bricked the chip while 
soldering the fine wires to the traces. Any info on this?

Original comment by harbury%...@gtempaccount.com on 19 Feb 2012 at 6:31

GoogleCodeExporter commented 9 years ago 
[deleted comment]
GoogleCodeExporter commented 9 years ago 
Irie,

the scroll problem was fixed in the latest firmware(s).
So what is your problem, make you think your ic is bricked.
In case:

http://er9x.googlecode.com/svn/trunk...se%20Brick.pdf

Original comment by mel...@gf-u.de on 19 Feb 2012 at 12:20

GoogleCodeExporter commented 9 years ago 
Maybe he means that the chip is broken, damaged..

Original comment by joaoalve...@googlemail.com on 21 Feb 2012 at 8:22