I'm using a Levoit Air Purifier 200s with openHAB 4.1.2. After adding the VeSync Bridge it's detected my three devices without problem. I created a model for one of them and linked the following channels:
Switched On
Filter Life Remaining
Operation Mode
Fan Speed
The first three are working without problems. Mabye there is one failure, i can set the Operation Mode to "Auto" thats not possible with the 200s but it's ok.
If I want to change the Fan speed openHAB always opens a chart and no selection.
Can you help me?
Is there an associated error message or log entry? I will leave this issue open for a bit to see if anyone has a similar issue but I would recommend trying on the OpenHAB forum.
I'm using a Levoit Air Purifier 200s with openHAB 4.1.2. After adding the VeSync Bridge it's detected my three devices without problem. I created a model for one of them and linked the following channels:
The first three are working without problems. Mabye there is one failure, i can set the Operation Mode to "Auto" thats not possible with the 200s but it's ok.
If I want to change the Fan speed openHAB always opens a chart and no selection. Can you help me?
And I always see "NULL" as State: