search

webhdx / PicoBoot

Raspberry Pi Pico (RP2040) based IPL replacement modchip for GameCube
GNU General Public License v2.0
1.48k stars 95 forks source link

Controllers ports 1-3 not working after picoboot installed #103

Closed fugi95 closed 11 months ago

fugi95 commented 1 year ago
Answer some general questions first
Which firmware version are you using? v0.2
Are you using the official Raspberry Pi Pico board? yes

Hi, I have lots of experience soldering so I don’t believe that’s the issue. I made sure my wires were 4 inches long and soldered everything nicely. Also put a piece of tape over the wires under the heat sync to avoid a short.

Issue I’m having is swish boots up and ports 1-3 on the GameCube do not work at all. Port four works but once I choose a game I can actually start the game once I’m in it because I’m controller 4.

Any advice ?

webhdx commented 1 year ago

Not related to PicoBoot. You either have failing capacitors and strange things are happening or you should reseat controller panel flex cable. It could've been damaged too.