Powering the FLIP board via 6v BEC.

wernerdaehn / CC3D-CableCam-Controller

CC3D and STM Cube based CableCam controller

Apache License 2.0

37 stars 15 forks source link

Powering the FLIP board via 6v BEC. #28

Closed DmitriySurin closed 6 years ago

DmitriySurin commented 6 years ago

My ESC is SKYRC 160. Built-in 6V/3A BEC. Is this OK for FLIP F32 board and signal from hall sensors?

wernerdaehn commented 6 years ago

Yes, no problem. Just connect the ESC to the Servo1 connector with all three pins, signal, +5V and GND. The Flip has a power converter built in to deal with every normal BEC voltage from 5V to 7V.