search

whid-injector / WHID

WiFi HID Injector - An USB Rubberducky / BadUSB On Steroids.
MIT License
1.66k stars 244 forks source link

Storage Full #9

Closed MooonShot closed 7 years ago

MooonShot commented 7 years ago

Hey I flashed with the Wifi Duck bin file after watching your video, I successfully flashed that but When I connect to AP I can't upload scripts It says storage full and Format button is not working

screen shot 2017-06-10 at 7 13 58 pm

whid-injector commented 7 years ago

You made some mistake for sure. And also check how to open tickets!!! Read it all carefully! https://github.com/whid-injector/WHID/wiki

whid-injector commented 7 years ago

This issue shows that the FS in the ESP didn't get initialized/formatted properly. You have to follow exactly how is showed in the video. With the same settings. If still persists might be your Arduino Version or the fact you use a USB 3.0 port.

About the reset Hall sensor it works. You just need to get used to it. (And of course, u need a magnet)

MooonShot commented 7 years ago

I did everything stated in video, I have USB 2.0 and It's not letting me upload payload with your firmware. This thing does not work. I need refund!

whid-injector commented 7 years ago

1) I am NOT the seller and I have ZERO profit on it. 2) Is like 99.99999% impossible is a defective piece. 3) I have tested 20+ devices and so far NO ONE broken. At most I had to reset it. 4) If people is not skilled enough to understand how one opensource gadget works... better don't buy and waste time of other people. 🤝

So far you are the first I see with this issue.

MooonShot commented 7 years ago

I very well know how gadget works, Any way to replace my product ?

whid-injector commented 7 years ago

Read point 1) and 4) again.

MooonShot commented 7 years ago

/\

whid-injector commented 7 years ago

Try contact the seller and proove them the HW is faulty.