I can operate 6 of these devices without issue, but the moment I connect a 7th, I immediately have runaway errors, causing the system to lockup due to the constant error stream.
Removing any of the devices, bringing the total in use back down to 6 recovers the loop error.
After this error and recovery, iw dev shows phy#'s much higher than actual devices connected, like phy#54, etc.
Still learning C, so not totally sure how to debug this directly, but going to take up the challenge and start googling each error with my fingers crossed..
Dmesg export, cleared, then plugged in 7th device to cause error:
I can operate 6 of these devices without issue, but the moment I connect a 7th, I immediately have runaway errors, causing the system to lockup due to the constant error stream.
Removing any of the devices, bringing the total in use back down to 6 recovers the loop error.
After this error and recovery,
iw dev
shows phy#'s much higher than actual devices connected, like phy#54, etc.Still learning C, so not totally sure how to debug this directly, but going to take up the challenge and start googling each error with my fingers crossed..
Dmesg export, cleared, then plugged in 7th device to cause error: