Closed Grey-Lancaster closed 8 months ago
I am having problems with the wall clock rebooting when I switch to it or apply to the NTP settings. I see sometimes I get an error that the NTP time could not be updated. Is there a wait time for it to sync or would it crash if it did not sync?
Soft WDT reset
Exception (4): epc1=0x40100254 epc2=0x00000000 epc3=0x00000000 excvaddr=0x00000000 depc=0x00000000
stack>>>
ctx: sys sp: 3fffeb20 end: 3fffffb0 offset: 0160
on boot sometimes: Gateway: 192.168.1.1 Subnet: 255.255.255.0 DNS: 192.168.1.1 HostName: wledPixel-5AAE MQTT Device Prefix: wledPixel-5AAE
ERROR: NTP time synchronization failed zone0 Message availabel: 8888
zone0 Message availabel: ip: 192.168.1.180 Init configuration ds18b20 measurement temperature: 76.2 F
Should be fixed in wledPixel v2.7
I am having problems with the wall clock rebooting when I switch to it or apply to the NTP settings. I see sometimes I get an error that the NTP time could not be updated. Is there a wait time for it to sync or would it crash if it did not sync?
Soft WDT reset
Exception (4): epc1=0x40100254 epc2=0x00000000 epc3=0x00000000 excvaddr=0x00000000 depc=0x00000000
ctx: sys sp: 3fffeb20 end: 3fffffb0 offset: 0160
on boot sometimes: Gateway: 192.168.1.1 Subnet: 255.255.255.0 DNS: 192.168.1.1 HostName: wledPixel-5AAE MQTT Device Prefix: wledPixel-5AAE
ERROR: NTP time synchronization failed zone0 Message availabel: 8888
zone0 Message availabel: ip: 192.168.1.180 Init configuration ds18b20 measurement temperature: 76.2 F