search

xblax / flashforge_ad5m_klipper_mod

Unoffical mod for Flashforge Adventurer 5M (Pro) 3D printers to run Moonraker, custom Klipper, Mainsail & Fluidd
GNU General Public License v3.0
82 stars 4 forks source link

Doesnt with with latest firmware #147

Closed insp1re1 closed 1 month ago

insp1re1 commented 1 month ago

Doesnt work with latest 2.6.5 firmware.

xblax commented 1 month ago

Yes that is known already. See discussion https://github.com/xblax/flashforge_ad5m_klipper_mod/discussions/144 We will enable support for the latest firmware in the next release.

insp1re1 commented 1 month ago

Could try leaving a note on the releases page, saves people wasting time.

On Wed, 17 Apr 2024, 00:54 xblax, @.***> wrote:

Yes that is known already. See discussion #144 https://github.com/xblax/flashforge_ad5m_klipper_mod/discussions/144 We will enable support for the latest firmware in the next release.

— Reply to this email directly, view it on GitHub https://github.com/xblax/flashforge_ad5m_klipper_mod/issues/147#issuecomment-2060086064, or unsubscribe https://github.com/notifications/unsubscribe-auth/BD6RWTJUXQBQMVXHNSUHLXDY5W22VAVCNFSM6AAAAABGKILTI2VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDANRQGA4DMMBWGQ . You are receiving this because you authored the thread.Message ID: @.***>

KaruroChori commented 1 month ago

From https://github.com/xblax/flashforge_ad5m_klipper_mod/blob/master/docs/INSTALL.md, one of the first few lines:

The mod installer currently requires that printers were updated to version 2.4.5 of the stock Flashforge firmware.

It is explicitly reported to work for 2.4.5, and the user is requested to have that installed. If people cannot read the documentation, there is no way to prevent them from wasting time :/