Open Kuckmalhierher-78 opened 1 month ago
Never seen this one before.
Looking at the threads on the klipper fora it's a motor problem. Try switching to the OEM firmware and see if it happens there. I'm pretty sure it will but that will confirm it's most likely a EM problem and not software related.
I tried the whole thing on a second Flashforge AD5M. Here too, the same error after a while. The funny thing is that this happens with the filament TPU from Overture on both devices. With PLA everything works for several hours without errors.
So I think it's the filament and not the AD5M.
Best regards
Hello, First of all, thank you for the Klipper variant for the AD5M. For 2 days now I have been getting this error when printing. The AD5M always breaks off at different points during printing. The cables look good and I have already changed the noozle. I have also restored the factory settings without success. Does anyone here have a solution?
My English is not good :-)
Greetings Sven