I'm not able to read the settings (memory) from TX when using ATMega128

What steps will reproduce the problem?
1. Click at "Read Memory from TX"

What is the expected output? What do you see instead?
Expected output is the window with displayed settings.
Instead, I get error message: "Error reading file: This might be a FW file 
(er9x.hex?). You might want to try flashing it to the TX. (Burn -> Write Flash 
Memory)"

What version of the product are you using? On what operating system?
- eePe Revision 343, May 8 2012
- ER9x-FRSKY-NOHT, r708
- Windows 7 Ultimate
- Turnigy 9X with MCU changed to ATMega128
- USBASP programmer

Please provide any additional information below.
I flash TX with ATMega128 without any problems. I was trying to use firmware 
released by you and built by myself with MCU = atmega128. I get the same 
problem in both cases.

Original issue reported on code.google.com by b.czerwi...@gmail.com on 27 May 2012 at 1:39

xhorizont / eepe

I'm not able to read the settings (memory) from TX when using ATMega128 #124