search

xperiments-in / xtouch

Other
570 stars 54 forks source link

Chamber Temp wiring is incorrect. #106

Closed crazyOC8 closed 4 weeks ago

crazyOC8 commented 4 months ago

Describe the bug I bought chamber sensor B and it arrived this morning. I printed the case beforehand then realized the case didn't fit. I wired it up anyway according to the guide and tried turned on the chamber sensor in settings (with screen off my printer). It read "5" then a second later read "-127" so I unplugged it. I grabbed the wires and they burnt me through the rubber. stupid wires. The chamber sensor also does not look like the one that goes in the case for chamber sensor B.

Steps to reproduce the behavior:

  1. Use chamber sensor B and wire it according to the guide.
  2. Turn on xtouch.
  3. Enable Chamber temp.
  4. Touch wires or pcb and get burnt (do not do this).

Expected behavior I expected to have a working chamber sensor, but it is wired wrong.

Screenshots There are no screenshots.

**XTOUCH

**Printers Printer info is unnecessary, it was not a problem resulting from the printer.

Additional context I think that the cable i was using to wire it may have been phony, but it came with the screen so i think it's right.

bpsmicro commented 4 months ago

Can you attach photos showing the wires to the ESP32 board, and the opposite ends where they connect to the probe? And the probe itself? Maybe one of us can spot what's awry.

corvankruchten commented 2 months ago

I had the same issue. Wired as on picture, but -127 and 5.....

xperiments commented 4 weeks ago

Any updates?. Seems a bad sensor... I close ATM. Reopen if needed.THX