Closed mike1808 closed 8 months ago
Need to check. Not sure is actually helpful. Maybe we can add a setting you need to change manually. Adding this setting to the UI will add a lot of complexity (now no setting is by ex entered by a number)
A offset setting in a Json file would be sufficient. Should be a one time configuration after assembly, right?
Yes, I will take care of it next week
On Wed, 1 Nov 2023, 22:15 TheDuffman85, @.***> wrote:
A offset setting in a Json file would be sufficient. Should be a one time configuration after assembly, right?
— Reply to this email directly, view it on GitHub https://github.com/xperiments-in/xtouch/issues/28#issuecomment-1789698276, or unsubscribe https://github.com/notifications/unsubscribe-auth/AADF7LJWACL3QO6ISEQDBATYCK3XTAVCNFSM6AAAAAA6KVHDJ2VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMYTOOBZGY4TQMRXGY . You are receiving this because you commented.Message ID: @.***>
Feature Description
Add an ability to offset the temperature sensor to calibrate it.
Justification
The sensor I got from the link are offset by 2-3 degrees. I checked the temperature using other thermometer and the sensor connected to xtouch is offset and linearly goes up and down.
Suggested Implementation (if you have one)
Allow adding positive or negative offset to the temperature.