Pressing "Confirm" button during the "Load" filament process (See "Image 2: Load Done / Confirm Prompt" below), does not extrude or advance filament as expected. (Even when a light force is applied to feed the filament).
Pressing "Confirm" sets nozzle back to "cooling temp" of 42C, then several seconds later, prompt user with Done / Confirm prompt again with nozzle at 42C. (See "Image 2: Load Done / Confirm Prompt" below).
To Reproduce
Steps to reproduce the behavior:
Power cycle Bambu Printer
Power cycle xTouch display
Go to "Filament screen" on xTouch.
Press "Yes" to confirm load process on xTouch.
Wait for nozzle to heat on Bambu Printer, and for Done / Confirm prompt to display on xTouch
Press the "Confirm" button on xTouch display.
Expected behavior
The unit should attempt to feed the filament for extrusion. (User must apply light force to feed the filament)."
The Bambu Printer's nozzle temperature should remain at 250*C
The "Done / Confirm prompt" should appear again after several seconds of attempting to advance filament.
Screenshots
XTOUCH (please complete the following information):
FW: v0.9.24
Printers (please complete the following information):
Describe the bug
To Reproduce Steps to reproduce the behavior:
Power cycle Bambu Printer
Power cycle xTouch display
Go to "Filament screen" on xTouch.
Press "Yes" to confirm load process on xTouch.
Wait for nozzle to heat on Bambu Printer, and for Done / Confirm prompt to display on xTouch
Press the "Confirm" button on xTouch display.
Expected behavior
Screenshots
XTOUCH (please complete the following information):
Printers (please complete the following information):
Additional context NA