After unloading temperature stays at 250C and cannot start new print

[php4umagento]

Describe the bug After unloading temperature stays at 250C and cannot start new print

To Reproduce Steps to reproduce the behavior:

1. Go to Filaments tab
2. Click on 'UNLOAD'
3. Wait for printer to heat up, cut filament then pull filament out of the tube
4. Observe that temperature stays on 250C

Expected behavior Printer should start cooling down and accept new prints

XTOUCH (please complete the following information):

• 0.9.24

Printers (please complete the following information):

• Device: P1P, P1S
• FW Version - 01.04.02.00

[xperiments]

duplicate of #47