Open michcfr opened 2 months ago
My tasmota works fine under ethernet, you can try resetting the device without doing anything and just plug in the network cable.
Thank you for your response.
The console confirms the Ethernet activation with the log: 00:00:01.828 ETH: Connected at 100Mbps Full Duplex, Mac 08:D1:F9:2D:35:BB, Hostname tasmota-2D35B8-5560-eth
BUT no IP address is assigned to the device. I had to set it in the console with the command: EthIPAddress 192.168.2.114 And then I had a page similar to your picture :-)
It seems that the firmware to do not set the IP address for the Eth?
Yes, the firmware uses DHCP to obtain an IP address by default
ok, now I know :-) By the way, what is the behavior of the Pairing button of the device? and how to operate it? thank you
Hello, I have successfully updated my ZB-GW03 with the v13.4.0 firmware.
But it seems that the Ethernet is not activated: When I click on the Informaton button I see the Wifi IP address but not the Ethernet IP address. Can you help me?