search

yaapu / FrskyTelemetryScript

A LUA telemetry script and widget for the Horus X10(S),X12 and Taranis X9D+,X9E,QX7 and X-Lite radios using ArduPilot frsky passthru protocol
GNU General Public License v3.0
434 stars 140 forks source link

Lost of the sensors when I change the model. #55

Closed fdapport closed 4 years ago

fdapport commented 4 years ago

Not sure if is a yaapu, Taranis firmware or APM firmware issue.

Hardware Radio Taranis X9D+, XSR Receiver, Betaflight F4 PRO V3

Firmware TX 2.3.7, RX 2.1.0, Ardupilot 4.0.5

When I change model on the radio some time I lost some sensors that I received from the controller via telemetry S.port inverted but I am still see the values in the yaapy screen display. If I go the telemetry setup menu of the radio I do NOT see the values received. To solve the issues I cancel all the sensors and I search again it in the telemetry radio menu and it find it again. The negative think of this procedure is that I lost all the configuration, like VARIO or voice setup of the value. Do you know if I known problem or where could it be solve?

yaapu commented 4 years ago

Yaapu doesn't use sensors.You can remove them all and it will work just fine. I inject simulated sensor data into OpenTX so the user can use them for vario etc. I see you are using ACCST 2.1 or ACCESS 2.1 which I never used so can't help much

fdapport commented 4 years ago

yes,, yaapu works great with any problems...I use ACCST 2.1.....The only problem happen when I try to set voice /alarms on the sensors, like this screen..,,

20200507_133422

some time I do not have any values---ONLY GPS 20200507_133435

Then I cancel the sensors and read again... and the special function get wrong senquence...see the screen 20200507_133540 20200507_133649

fdapport commented 4 years ago

Resolved: It is NOT a issue related with Yaapu script but is related with save models in Companion script. See link: https://github.com/opentx/opentx/issues/7613