New APM modes (ACRO, CRUISE) not shown on OSD

[GoogleCodeExporter]

What steps will reproduce the problem?
1.Update to latest arduplane firmware 2.7.4
2.Enable a new mode for selection (ACRO or Cruise)
3.Select the new mode, and the OSD keeps displaying the previous mode.

What is the expected output? What do you see instead?
expect to see actual mode the apm is in, instead seeing previous mode.

What version of the product are you using? On what operating system?
APM 2.7.4 

Please provide any additional information below.

Original issue reported on code.google.com by JohnnyFa...@gmail.com on 18 Sep 2013 at 9:06

[GoogleCodeExporter]

I must have had an issue with the flash or charset or something. I reflashed 
and reloaded the charset and it is now displaying properly. Please disregard. 
Thank you!

Original comment by JohnnyFa...@gmail.com on 18 Sep 2013 at 9:28

[GoogleCodeExporter]

I have the exact same issues..what hex file and char set did you reflash 
with...thanks. Is it  minim 2.2 hex file and lates_char set or osd_char set.  
Thanks..

Original comment by wingyee1...@gmail.com on 9 Oct 2013 at 12:50

[GoogleCodeExporter]

Minim osd 2.2 and latest charset. I was told that you need to power the 12 volt 
side of the mavlink while uploading the charset since the video chp is not 
powered by the 5v side from usb. Have not tried it yet though.

Original comment by JohnnyFa...@gmail.com on 9 Oct 2013 at 5:50

[GoogleCodeExporter]

Thanks Johnny.I powered up the 12V side and flash the minimosd 2.4 r693 hex and 
latest_charset and it worked .Thanks for your help....

Original comment by wingyee1...@gmail.com on 12 Oct 2013 at 1:36

[GoogleCodeExporter]

Same goes for Autotune mode.

Original comment by andre.kj...@gmail.com on 6 May 2014 at 8:13

[GoogleCodeExporter]

Closed as we have a new version.

Ifthe problem is still present please reopen it.

Original comment by gabek...@gmail.com on 28 Nov 2014 at 11:44

• Changed state: Done