Hello,
Yesterday I received two USBasp cables and tryed to flash my stock Turnigy 9x.
first, all went bad, the first USBasp refused to read the EEPE, then I started
the radio : she was out of service, only the backlight start, the radio doesnt
start at all.
I tryed the second USBasp, he told me that the device id is not as expected,
and asked me to use the -F option. As the radio was dead anyway, I used this
option in a command line. In the begening it does not work because the
post-flash verification was not successfull, but after some hours of tryed the
firmware was finaly successfully writen, and the radio started with Open9X.
At first she told me that the EEPE is invalide and she formated it, I have
access to menus etc, everything seems ok on the radio, but it wont controle any
receiver.
First I tryed on a tricopter with the kk2 board, and on the "receiver test"
menu, I see some strange values (143,53,53,-3) that does not change when I move
the sticks.
I also tryed with a simple receiver + esc + 1 servo. When I connect the
batterie, the ESC start making uninterrupted and fast biip+biip+biip+..
I tryed to calibrate the ESCs, I put the throttle at the higher position,
connect the batterie to the esc, he make the two biips, but when I put the
throttle in the lowest position, he don't make the 3 confirmation biips, as if
I havent moved the throttle.
is there any option I should use in Open9x? I'm using it with default values.
Regards,
Original issue reported on code.google.com by fouadtangerois on 6 Sep 2013 at 12:19
Original issue reported on code.google.com by
fouadtangerois
on 6 Sep 2013 at 12:19