search

zuidwijk / esphome-doorbell

ESPHome based DoorBell
61 stars 17 forks source link

Contacting Marcel #17

Open AtomicLaser opened 2 months ago

AtomicLaser commented 2 months ago

Have been trying to get hold of Marcel since 4 August with no response,

Trying here instead.

@zuidwijk

Some bad news I'm afraid, Finally managed to find time to pop round to my brother's house to install the 2nd doorbell ESP I ordered and sadly it seems to be "dead"

The power light comes on regardless of being powered by the doorbell though the screw terminals and the USBC port.

I’ve managed to get the Doorbell ESP connected to the serial port via the USBC port, tried to re-flash the board using the script on your website but it’s telling me to hold the boot button? (see attached) Unknown

Any ideas?

Not sure what your returns policy is, but would it be possible for a replacement to be sent out at all?

Thanks

Chris

florian-e2211 commented 2 months ago

Hello, the same thing happened to me, it ran for a few days, then the doorbell was offline. The red lamp lights up.

When I transfer again via ESPHome I get following error message: ERROR Running command failed: Failed to connect to ESP32: No serial data received.

I wrote an email to Marcel Zuidwijk (support@zuidwijk.com), but didn't get an answer either 😢