Open zumdar opened 3 years ago
back panel: 10.75mm diameter dc in
19.5mm diameter switch w/ 2mm notch on 1 side
could i route out a channel on the back so the entire back panel could slide off?
mg90s servo look for design file online
mic mounting hole - 10mm
mounting holes for arduino
penduluum arm, stepper motor arm
get switch cap and measure make sure filter knob will fit 8mm hole
screws and standoffs 4x M3 - arduino 4x M3 - ext to clock face 2x M3 user interface 2x M3 - voltage converter standoffs for the clock face
make hole mount for servo add top mounting holes for pcb add hole for button holes for pots