-
https://www.smartnydom.pl/forum/firmware-do-przelacznika-sonoff/stacja-pogody-esp8266-afe-firmware/paged/2/#post-6769
-
https://www.smartnydom.pl/forum/szybkie-pytanie-szybka-odpowiedz/wgranie-afe-firmware-do-esp32/#post-31295
-
Hello,
I attached both temperature sensor and extnernal bistable switch to sonoff basic.
If bistable switch is ON (loop closed = GND is connected to GPIO1), then after powering off sonoff it won…
-
**Environment**: Linux Mint 20, amd64
**UPS board**: OpenUps2
**openups version**: 1.0
```bash
$ sudo openups -t openups2
openups version 1.0. Device selected: openups2
Selected device ope…
-
I have compiled the driver and loaded it but when I try to read data from the endpoint created in /dev/fpreader0 I don't get any data.
insmod ft9201.ko
`[ 1688.853717] usbcore: registered new i…
-
#### Description
Credo transceivers are not coming up after "shut / no shut" on Dell devices. To bring the interface up on Dell side, a flap is required on the peer end.
#### Steps to reproduce …
-
This one:
https://github.com/JordanAceto/Magpie/blob/710b1f07e04fe3cf03bed5014f1b3d6927cb5d44/main_microcontroller_firmware/examples/afe_cli_control/main.c#L3
Update this comment block to represen…
-
-
-
The hub design is finalized.
The box was equipped with several diagnostic LEDs. Every AFE channel has 3 LEDS:
- connection OK. It is on after CPU detects valid CAN endpoint.
- 5V rail overcurrent
…