-
Does anyone else see this issue on macOS 15? This was working on macOS 14.
```
$ sudo arp-scan -l
WARNING: Could not obtain IP address for interface ap1. Using 0.0.0.0 for
the source address, w…
-
Hello,
i am encountering the following issue:
on Version 1.10.0 whenever i scan my local device network a specific device by Dell with the vendor ID 28:00:af and ac:91:a1 show up as unknown, al…
-
Hello,
I wonder if it's possible to automate SNMP ARP scans in cron for exemple, just like ping scans.
i'm not very good in developpement and php, so I just ask if it is possible to do this, or…
-
### Windows Version
Microsoft Windows [Version 10.0.26100.2033]
### WSL Version
2.3.24.0
### Are you using WSL 1 or WSL 2?
- [x] WSL 2
- [ ] WSL 1
### Kernel Version
5.15.153.1
### Distro Vers…
-
I installed it, added it to the configuration and restarted HA. But where do I see the results of the scan?
And in terminal if I type arp-scan I get this:
 to determine the open port, nmap successfully sends the SYN packet, the target successfully accepts and returns SYN+ACK, but nmap does not receive SYN+A…
-
We updatet to 1.5.1 and enabled SNMP for our core switches.
So far so good, all new discovered IP Addresses get their MAC Address written.
But all existing entrys still get no MAC.
How can i as…
-
I followed your article on Medium - great writeup.
When I have applied the yaml against my cluster (there is 9 nodes), two of the nodes have ended up with the same IP address. I could see this by …
-
Hello,
I dont know if it is a bug or normal behaviour but when I start an ARP scan from a specific subnet, it returns all results from all SNMP configured devices. Is it the correct behaviour somet…