-
### Qubes OS release
R4.2 with latest testing update
### Brief summary
Software using libfido2 cannot detect CTAP proxy device.
### Steps to reproduce
1. Install Qubes CTAP proxy and `fido2-t…
zpc0 updated
5 months ago
-
Valid Solo - FIDO2 (USB only) USB-A with firmware 4.1.2 locked from SoloKeys on ArchLinux solo-pythob version 0.0.30.
"solo key reset" was done. No PIN.
"solo key credential info" and "solo key cred…
-
[How to file a helpful issue](https://www.qubes-os.org/doc/issue-tracking/)
### Qubes OS release
R4.2
### Brief summary
Try to register or authenticate with Qubes CTAP, notice that when th…
-
ryan@STARFORGED:~/uru-card-fido2-authenticator$ platformio run --target upload
Processing esp32dev (platform: espressif32; board: esp32dev; framework: arduino)
--------------------------------------…
-
*Contact*: Brianna Murdock / Jen Harmon
*Who*: Tuition Reimbursement Employee
*What*: Employee capability to provide Tuition Corrections
Employee ability to provide corrections:
- Correct Course…
-
### Qubes OS release
R4.1.2
### Brief summary
I'm following [the documentation](https://www.qubes-os.org/doc/ctap-proxy/) to set up the CTAP proxy, but they're either incomplete or the prox…
xyhhx updated
4 months ago
-
The test tool currently supports commands from version 2.0. `GetInfo` informs about supported versions.
For old commands, tests should differentiate between authenticator versions.
For new command…
-
> Yes, in 4.2 you can configure it with "qubes global config", including enabling/disabling it per-qube - it will setup appropriate qrexec policy.
Starting from no configured access t…
-
I'm working on the support of WebAuthn over USB. For this, the Android device needs to have special USB HID descriptor (CTAP) and Authorizer needs to implement the device logic (key creating and authe…
-
[How to file a helpful issue](https://www.qubes-os.org/doc/issue-tracking/)
### The problem you're addressing (if any)
The service `qubes.UpdatesProxy` uses `@default` as the destination and `sy…