-
### Hardware
ESP32
### Firmware version
v2.4.6
### Application version
v2.4.6
### What happened? What did you expect to happen?
Hi. Does this work with an ESP32-C6 or do I need a different chip…
-
Hi @fsaris, thank you very much for this component! I've since the beginning wanted to have a more reliable solution than the Home Assistant integration.
I have an `esp32-c6-devkitc-1` board and wa…
-
I encountered issues while compiling a project using the M5GFX library with an ESP32-C6. The error suggest compatibility problems with the ESP32-C6 platform. Below are the details:
**Steps to Repro…
-
If I'm not mistaken, the ESP32-C6 (and the ESP32-C3) can enable a Serial Monitor by sending a command to the bootloader. Afterwards, serial output (e.g. `Serial.println("Hello!")`) could then be recei…
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
### The problem
I'm using ESP32-C6 with bh1750 sensor. It needs I2C. Enabling I2C leads to regular continuous runtime crashes. The watchdog restarts the device, but it crashes again.
### Which versi…
-
I have noticed that there is no Xiao ESP32-C6 3D file out there so I went ahead and created one and posted it on [GrabCad](https://grabcad.com/library/seeed-studio-xiao-esp32-c6-1).
I was not sure …
-
I am trying to run two BLDC gimbal motors on ESP32-C6.
When using only one of the motors everything works fine.
The problem is with MCPWM setup when using second motor - error log:
```
=====…
-
Hi. thank for releasing the update!
I am getting either this compiling for ESP32-C3 Mini
```
exit status 1
Compilation error: exit status 1
```
or the attached for ESP32-C6-WROOM-1
[C6.tx…
-
@FutureProofHomes @that1guy @alextrical please consider also adding an ESP32-C6 (or ESP32-H2) as a "coprocessor" module as well to the same FutureProofHomes Satellite1 Development Board, i.e. add a se…
Hedda updated
3 weeks ago