-
### Version
2.1.9
### Hardware / Firmware
GRBL 1.1
### What happened
this text is netbeans ide not ugs
…
-
### Version
2.1.9
### Hardware / Firmware
GRBL 1.1
### What happened
I create a new design and put in the cutting requirements but the visualizer dose respond and i cant send to the machine.
##…
-
Hello,
I want your team to develop firmware for GRBL.
Thanks.
-
### Version
2.1.9
### Hardware / Firmware
GRBL 1.1
### What happened
"An error was detected while sending 'G2X-3.185Y-78.449I0J0.589': (error:1) G-code words consist of a letter and a v…
-
I am looking for a way to output the current x,y,z coordinates to a txt file at several spots in a g-code file. This will be on a CNC 3018 pro driven from Candle V1.1.7
I believe that the Mach 3 cnc…
-
hello terje i build firmware via STM32 bluepill web builder, i have connected EStop or Reset, Cycle Start, and Feed Hold to ground but grbl firmware can't be run on openbuilds, ugs, and io sender, las…
-
The software have been tested only with marlin for the moment.
It should be compatible also with grbl and others but I need someone to test it on real hw (at the moment I cannot try it out on my ow…
-
### Version
2.1.8
### Hardware / Firmware
FluidNC
### What happened
UGS Wont connect to machine using the FluidNC drop down, it keeps telling me...
*** Fetching device settings
*** Could not es…
-
After doing a mpos homing the arrow direction buttons only work in a positive direction.
Before homing the machine will work flawlessly.
I tested my machine using both LaserGRBL (latest version) …
-
Hello everyone,
I just bought a DLC32 card with a TS35 screen.
The firmware installed on the card indicated by the GRBL console is:
[PRODUCER:MKS DLC32]
[V2.30(8M.H35.20231206)]
[VER:1.1h.202…