-
Every time I try to update my WiFi settings with the provided script, it fails to initialize the wireless interface, and ifconfig only shows the loopback interface.
-
# Bug description
When using the ifconfig command, only ipv4 addresses are shown on the en0 interface
# Screenshots
# Steps to reproduce
1. Run the ifconfig command in mashREPL
2. See that …
-
**[MANDATORY] Describe the bug [MANDATORY]**
This is the output of `bastille setup`:
```
bastille_enable: YES -> YES
Configuring bastille0 loopback interface
cloned_interfaces: lo1 bridge1 ->…
zilti updated
15 hours ago
-
Hello, I cannot find the port name for the robot, which is A1. When I write **ifconfig** without any ethernet cables connected, that's what I get:
```
~$ ifconfig
enp4s0: flags=4099 mtu 1500
…
-
Hello,
ifconfig is obsolete on Linux and should be replaced by ip. On some Linux distributions, ifconfig is no longer (pre)installed.
```
$ sudo meshtastic --tunnel
Connected to radio
INFO file…
-
Hello, I have tested ~20 packages today and I found some interesting things about ip and ifconfig on iSH :
`ip route get 1` give me `ip: socket(AF_NETLINK,3,0): Invalid argument`
`ifconfig` give me…
bc1bb updated
1 month ago
-
While running the command ifconfig in Kali Linux I am facing the following problem please help me to way out
ifconfig
Warning: cann…
-
I already submitted Feedback to Apple, but figured I would report things here too in case someone may discover a workaround.
macchanger worked without issues on macOS 14.3.1.
After updating to 1…
-
I was just going through your full-node guide, looking for some ideas on how to configure my network settings just right. I noticed that under the section about DCHP configurations, there is mention …
-
the `ifconfig` command is deprecated. It doesn't appear to be used much in our codebase, so it shouldn't take much to remove it.