-
### Mainsail Version:
2.12.0
### Browser:
Edge
### Device:
Laptop
### Operating System:
Windows
### What happened?
I have multi color LEDs connected to a PCA9632. This device is connected by…
-
Manual: http://www.nxp.com/documents/data_sheet/PCA9632.pdf
Source: https://github.com/networkimprov/linux/blob/anvl-v4.7/drivers/leds/leds-pca963x.c
Restore state after suspend/resume (not necessary…
-
I have Neopixel enabled in Marlin as follows:
// Support for Adafruit Neopixel LED driver
#define NEOPIXEL_LED
#if ENABLED(NEOPIXEL_LED)
#define NEOPIXEL_TYPE NEO_GRBW // NEO_GRBW / NEO_GRB - fo…
-
After some trial and error I got my RGB leds to work.
Strip of 59 leds powered by an external wall powersupply .
https://imgur.com/a/lEBhNcu
Sharing my solution here as I spent way to much time o…
-
Hello John,
Let's look at my similar project. [https://github.com/mamin27/ecomet_i2c_raspberry_tools](url)
There is many i2c sensors that could be integrated in one platform. We could produce mor…
-
### Feature Request
Hello,
My team and I would like to have support for a 'toolhead' we are developing. Its primary features are:
1. I2C temperature sensing
2. I2C Fan control
3. Hall effect…
-
I apologize if this isn't the correct place to ask this - new to github
Would one be able to use a thermocouple through the adafruit board wired this same way?
Does PT100- analog = a thermocoupl…
-
Source: https://github.com/networkimprov/u-boot/blob/anvl-v2016.09/board/networkimprov/anvl/anvl.c#L488
What is cause of:
`i2c_write: error waiting for data ACK (status=0x116)`
Indicate start of u-b…
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
Using latest build 4.3.9
Have rocking hotend and using Dondolo dual extruder Bowden . (Hotend 1 to the left, z probe in the middle and hotend 2 to The right).
Dondolo servo index is 1, the other "…