-
- [x] Umbilical connectors on both sides to be in par with the cable routing observations (two rows on the inside)
- [ ] Umbilical connectors on the outside to be accessible from the testpod window.
…
-
Pcb with a size of fkm top cover, with buttons, rfid, jack's soldered directly onto PCB - so less cables.
Remaning cables:
- LCD (4PIN connector)
- ON/OFF Switch (2PIN connector)
Layout idea:
![Ima…
-
Design a UHF (e.g. 70cm) PCB for use with a DRA818U chip, the main challenge will be figuring out how to filter spurious emissions (need to see if components with values that low are available and/or …
-
Hello, I've been working on a pcb design. This design is untested and I'm unsure if works, this pcb cost around $40 - $50. The 3.7v to 5v might not work, I'm going to provide the gerber file if you'd …
-
Some are 30-pin, some are 38-pin, and even within those there are narrow and wider widths.
It would be good to have 3 or 4 variants of the PCB that support all of these (with an associated list of …
-
Design a dual VHF/UHF PCB, for use with BOTH a DRA818V and a DRA818U. The board will be larger, so needs a new 3D printed cases for this one too. I imagine this needs a diplexer on the PCB to ensure t…
-
Putting finishing touches on current PCB design in KiCAD. Will be ready for revision by 7/25
-
Hi, I am interested in the board, but I get an error when trying to open EAGLE PCB design.
Regards,
Ivan
-
I use local PCB vendor to build pcb. When i send them gerber file, they said that the design is missing keep out layer.
I dont know what it means. Any help
-
Hi,
I found about the Hackberry via youtube, and wanted to make one, but I see you haven't released the design files. I saw you're selling fully assembled ones on your Tindie, but I wanted to make my…