-
Hi,
On 2.2 PCB, I see that the PCMCIA connector is an ```FCI-10014744-002SLF``` and is out of stock/obsolete in Farnell and Mouser and pretty much everywhere, do you known a replacement for it ?
-
Any expected memory retainment time known ?
-
It would be good if Minimig will be able to use PCMCIA virtual CF card. I think most modules used for IDE can be adapted for PCMCIA. It should be just another IDE port (with small variation), isn't?
…
-
When trying to use a Prism2 wifi card on an A600 with Emu68 it causes the machine to hang/freeze, and the only way to recover is to hard reboot the machine.. Cards work fine when used without Emu68.
…
-
Hi Devs:
I worked on loongson3 platform to build kernel 4.14.74 can go pass. but rpmbuild run depmod said something wrong as below, anyone has this expirence:
my build env is:
compileris : …
-
I have Gentoo and installed it; I have kernel 5.6.14 if that makes a difference. It just says Probe for hardware ... and does nothing after that.
-
### Description
MAME CHD disk images can contain the PCMCIA CIS from a PCMCIA or CompactFlash device. It is currently ignored.
-
The Memory Card PCMCIA selected in Mouser Part does not fit. Don't use.
-
**Describe the bug**
on dracut-ng 060 and higher (tested up to 105), my aarch64 laptop (lenovo x13s) does not load many essential modules during the initramfs phase of boot, leading to many parts o…
-
There is a different CPM variant that run on the NC100, which is basically able to run via function-X keypress from a ram card. Would be possible to do the same on cpmish so you can bypass the floppy …