-
Hi,
I rebulilt this project following your instructions which made the process smooth, thanks. I found that when I want to use PPS voltages the power supply and/or circuit restarts after some seconds…
-
Hello,
I have two servers running pktgen-dpdk. One server send packet and the other server receive the packet.
Does pktgen-dpdk have feature to control PPS rate?
For example, I want to send …
-
How to use PPS?
Could I know some pps using example?
-
PPS calibration does not apply new settings until 'Burn' is hit, auto-calibrate requires 'burn' to apply TPS
we shall improve usability by burning automatically after every second PPS calibration a…
-
previously discussed here: https://github.com/tooyipjee/Spark-Analyzer/issues/2
it seems that the WebApp_PPS falls back to delivering 5V if the power supply is not PPS capable. This could lead to p…
-
OCP-TAP has announced the [TimeHAT V2](https://www.linkedin.com/posts/ocptap_here-is-the-timehat-open-source-and-available-activity-7228207468282003456-lUv9/), a Pi 5 HAT that embeds an Intel i226 NIC…
-
repro:
* flash PPS
* configure levels
* -> correct levels set
* unplug/replug
* -> levels are forgotten - NOT OK: levels should be remembered
As far as I can tell, WebApp does this just fine.
-
Hi there,
Recently I've been looking into syncing my lidar and IMU via a PPS signal. However, all this is relatively new to me. Let's assume I am a complete beginner with this and I have the follo…
-
To enable the GPS as a pps source. Do the following.
add "dtoverlay=pps-gpio,gpiopin=25" to a new line in /boot/config.txt
add "pps-gpio" to a new line in /etc/modules
install pps tools:
sudo apt-…
-
Noticed you have a v2 in the works and have chosen the FUSB302 USB PD controller. It's my understanding that the FUSB302 doesn't support PPS. There are others, like the AP33772 that does support PPS, …
gc-ss updated
2 months ago